PROBLEM: None of the machine functions will work and oUErrUn is showing in the display. This is normally caused by a box being left under the feed table and the table being lowered onto it.

SOLUTION: On a machine with ver. 1.1.7.1 software (The software version is displayed during power up. UEr.X.X.X.X.) you place a jumper between wires 44 and 50 at connector X12 on the board (the 5th connector from the left along the bottom of the board), then press the button to move the table off the overrun switch. Once the table has cleared the overrun switch remove the jumper (CAUTION...PUTTING A JUMPER BETWEEN WIRES 44 AND 50 BY-PASSES THE SAFETY SWITCHES SO IF YOU PRESS THE WRONG BUTTON OR YOU FAIL TO REMOVE THE JUMPER AFTER THE OVERRUN IS CLEARED THE MACHINE COULD BE DAMAGED).

On some machines with ver. 1.3.A software you need to turn off the main power then install a jumper between wires 44 and 50 at the terminal strip in the lower left side of the electrical box. Turn the power on. Do not press any buttons until the power up cycle is complete and the count screen appears. Then press the button to move the table off the overrun switch. Once the table has cleared the overrun switch remove the jumper (CAUTION...PUTTING A JUMPER BETWEEN WIRES 44 AND 50 BY-PASSES THE SAFETY SWITCHES SO IF YOU PRESS THE WRONG BUTTON OR YOU FAIL TO REMOVE THE JUMPER AFTER THE OVERRUN IS CLEARED THE MACHINE COULD BE DAMAGED).

On some of the latter machines with ver. 1.3.A software and all the machines with ver. 1.3.C software there is a toggle switch located in the plastic cover in the lower right side of the electrical box. On these machines you turn power off then if the table has activated the lower overrun switch hold the toggle switch down, if the table has activated the upper overrun switch hold the toggle switch up. Turn the power on. Do not press any buttons until the power up cycle is complete and the count screen appears. Then press the button to move the table off the overrun switch. Once the table has cleared the overrun switch release the toggle switch.

** End of Document **