There are two things to check, both dealing with the top sensor (the sensor located right above where the paper feeds into the fold rolls):

1. The bottom of the sensor must be even with the bottom of the nip guard, which it is mounted to. If it is not even, loosen the screw in the sensor and reposition it.



2. Is the sensor lined up with the hole in the feed table? If it is not lined up, loosen the screw holding the sensor and adjust the sensor, remembering step 1 above.

Copyright © 1998-2000 Baumfolder Corporation,....All rights reserved
Page Last Updated October 6, 2000
** End of Document **