Our technical support group will add to this list as needed. If you have a question not addressed below please call toll-free, 1-800-543-6107 and direct your questions to our technical services department.
Or, if you prefer, e-mail us at techservice@baumfolder.com
Thank you for your interest in Baumfolder products.
Older Folders and Cutters
2020, 2018, 2015 Folders
714 Table-top Folders
1. If the counter is not working and the counters are one of the following: BC-100, BC-200, BC-300, DATATRAC III, DATATRAC I, OR DATATRAC IV
Contact: P.D.I. Systems; Indianapolis, IN; Phone# (317)247-0640.2. For Lawson-Baum Cutters please contact:
Lawson Service Phone# (800)265-2702.3. How do I set the Feed Caliper?
4. How do I adjust the pile height?
5. I am Rebuilding my folder, how do I set the Fold Rolls and Fold Plates to the fold rolls?
...For the following Models: Mark I, Ponys, Jr. Jet, 017, 400, 500, O&M, and Futura Series
directions are here.
...For the Models: Mark II, 200 and 700 Series directions are here.1. I have FC Relay Messages - Check the following fuses. F1 & F2 on the circuit board.
2. I have CLR Stop Message - Check the fuses F8 & F9 on the circuit board.
3. Overrun Message, Service Bulletin
4. Inch/Metric - Length will not go under 150 - Length is now in metric. How do I change this?
5. How Do I Install Static Eliminator Bars?. The answer is here.
1. On 714A or B with Air, I just changed tires on sucker wheel, Now I'm having trouble feeding. What do I need to do?
2. On 714 the drive motor keeps shutting off. Whats wrong?
3. How do we set-up to Score or Perf?
4. I run a lot of 'Z' fold work and I have sheets jamming and missing the number 1 fold plate. What can I do?
5. I am getting a wrinkle on the trailing edge of my paper that runs perpendicular to the fold. What is wrong?
6. On my 714MP I am always getting the error message 'folder jam'. What is wrong?
Last Updated October 6, 2000 